Maintenance
7-49
7
P/N 6525032M1 - X6
150 HOUR MAIN SERVICE
WARNING: If you need to open the bonnet, follow the procedure indicated under "How to open the bonnet".
WARNING: Always use the specific PPE for the operation concerned.
WARNING: Maintenance operations must be carried out when the engine is off. Make sure that the hand brake is
engaged and the key is not inserted in the dashboard.
WARNING: Beware of burns caused by hot tractor and engine parts. [4.1.n]
STEP 30A
Oil change in front suspended axle (if equipped) and front final drives
NOTE:for oil specifications, refer to the Lubricants and Fuel chart in section 9 of this manual.
WARNING: Before carrying out any servicing on tractors equipped with independent front suspension,
make sure the axle is fully lowered to the bottom mechanical stop, the engine is not running and the
keyswitch is in the OFF position. Failure to do this may result in serious injury.
1. Differential oil fill plug and level
2. Differential oil drain plug
3. Oil breather
4. Epicyclical final drive fill, level and drain plug
5. Greasing point
6. Brake system bleeding
Axle oil change
STEP 1
Put the tractor on level ground and put a suitable size
container under the drain plug.
To Next Page
Loading...