7-30
Maintenance
X6 - P/N 6525032M1
STEP 13A
Fuel/water separator filter
WARNING: If you need to open the bonnet, follow the
procedure indicated under "How to open the bonnet".
WARNING: Always use the specific PPE for the opera-
tion concerned.
WARNING: Maintenance operations must be carried
out when the engine is off. Make sure that the hand
brake is engaged and the key is not inserted in the
dashboard.
WARNING: Beware of burns caused by hot water and
engine parts. [4.1.n]
Regularly drain off the water that collects from the
cock of the water/fuel separator filter (1).
The drain plug is located on the bottom of the fuel/water
separator. Loosen the plug to let any water or sediment
drain from the filter. Tighten the drain plug after the water
has drained.
IMPORTANT: Dispose of fuel and filters in accordance
with local regulations. DO NOT drain on the ground, into
a drain or into a leaky container. Be responsible for the
environment.
During running-in, replace the fuel filter 2 times after
the first 50 and 100 work hours. Afterwards, replace
the fuel filters after every 500 hours service.
WARNING: Always use the specific PPE for the opera-
tion concerned. Beware of burns caused by hot water
and engine parts.
Shift the gear to neutral and engage the parking brake.
WARNING: If you need to open the bonnet, follow the
procedure indicated under "How to open the bonnet".
To Next Page
Loading...