7-70
Maintenance
X6 - P/N 6525032M1
STEP 47A
Check and replace (if needed) the oil
filter on the intake of the steering
system
WARNING: Clean the filter on the intake of the steering
and hitch circuit pumps after the first 50 hours, then
every 250 hours service.
1 - Loosen the screws (1) and remove the cover (3) of
the intake filter (2).
2 - Remove the filter cartridge (2) and wash it in a suitable
solvent. Be sure to remove any metallic fragments
from the filter cover and housing.
NOTE: Replace the cartridge if damaged or excessively
clogged.
3 - Clean and reassemble the cover.
4. Check the oil level. Top up if necessary with oil of the
prescribed type.
NOTE:After you have fitted the filter, allow the engine to
run and make sure that there are no leaks. Check the oil
level at regular and top up if required.
NOTE: Use the oil prescribed in the Lubricants and Fuels
chart in the section 9 of this manual.
NOTE: Make sure that the hydraulic equipment con-
nected to the tractor's hydraulic circuit uses the same
type of oil. Use of different types of oil could damage the
hydraulic circuit.
To Next Page