Argo McCORMICK X6.430 STD/LS - Safety - Cab

2-4
Safety notes
X6 - P/N 6525032M1
SAFETY - CAB [4.1.q]
The safety cab is designed on purpose for this tractor
series and complies with all law requirements concerning
safety and noise level.
The safety cab complies with international safety stand-
ards prescribed by laws in force. The cab MUST NEVER
be drilled or modified in order to install accessories or
implements. IT IS FORBIDDEN to weld components to
the cab or to repair damaged cab components. Never at-
tach chains or cables to the main framework of the cab
for towing purposes.
WARNING: Tractors equipped with cab have a
roof compliant with standard OCSE Code 10
that gives a limited protection against objects
and loads that might fall from above in typical
work conditions, but not against objects and
loads that might be projected into the area
normally occupied by the operator.
• Seat belts must always be worn and adjusted snugly
(Fig.2-2).
• From time to time, check the seat belt for damage and
replace it if worn or damaged (Fig.2-2).
WARNING: Always fasten your safety belt.
After an accident, let a specialised workshop check the
safety frame, the driving seat, the safety belts and the
anchor points of the safety belts. Replace all damaged
parts before using the tractor again.
Fig.2-1
Fig.2-2