Operation
5-57
5
P/N 6525032M1 - X6
Fig.5-32
USE OF THE ELECTRONIC hitch
Activation and operation
The hitch incorporates a safety device which disables its
controls when the engine is off or if the external controls
have been used. This prevents accidental movement of
the lift links and links in the case anyone should change
the control settings while the tractor was stationary. When
the engine has been started, or after the external controls
have been used the hitch is locked. To start again, simply
turn the control switch (1) to position C.
- If the switch is already in Pos. C, turn the switch (1) to
Pos. A then back to Pos. C again.
- If the switch (1) is not in Pos. C and the hitch is lowered,
turn switch (1) to Pos. C.
WARNING: The hitch links will raise as soon
as the hitch is activated. Limit the max. lifting
height with the control (7) before re-activating
the electronic hitch.
- If you need to stop hitch movement imme-
diately, simply turn the switch (1) to Pos. B.
- Before you enable the hitch controls, check
that the settings of controls (3 and 2) do not
cause any dangerous movement of the imple-
ment.
NOTE: The electronic hitch control system also incorpo-
rates safety devices which disable its functions if any of
the following faults are detected:
1 - Insufficient battery power.
2 - Short circuit in the power line.
3 - Faulty position-control circuit.
If the electronic hitch fails to operate correctly after the
controls have been enabled as instructed above, have
the circuits checked by your local Argo Tractors Dealer.
WARNING: External controls must be operated
at a safe distance, standing on one side outside
the tractor and out of the overall width of
mudguards. It is expressly forbidden to oper-
ate the controls from the rear of the tractor or
standing on the inner side of wheels.
To Next Page
Loading...