Maintenance
7-33
7
P/N 6525032M1 - X6
STEP 16A
Fan and alternator belt
WARNING: If you need to open the bonnet, follow the
procedure indicated under "How to open the bonnet".
WARNING: Always use the specific PPE for the opera-
tion concerned. Beware of burns caused by hot water
and engine parts. [4.1.n]
Periodically check the tension A of the alternator and
fan belt in the middle of its longer side. It should give
1÷1.5 cm.
To adjust the belt tension, loosen the fixing screws and
check nut on the idler and move the alternator until the
correct tension has been obtained.
Now tighten all the screws and check nuts.
NOTE:Check the belt conditions frequently. The belt
must be replaced if it is cracked or needs to be frequently
adjusted. This operation must be carried at your Argo
Tractors Dealer's.
NOTE: Check the condition of AC compressor belt fre-
quently.
To Next Page
Loading...