3-2
Controls - Cab
X6 - P/N 6525032M1
CAB
All non-metallic components within the cab comply with the ISO 3795 standard.
The cab is approved according to OECD codes concerning ROPS test (protection against overturning) and safety belts.
Cab
The cab is made of steel sections and is fastened to the
tractor by means of a double system of rubber dampers
(silent block) protecting the driver's seat both from vibra-
tions and from engine noise. The noise peak is therefore
limited to low values, for greater comfort for the operator.
Doors (1)
Both doors can be opened both from the inner and outer
side, and kept open by dampening cylinders. Both doors
are provided with a lock with key.
Rear window (2)
Release the rear window lock and turn the handle (3)
counterclockwise to open it. The window is kept open
by dampers.
Field lights
The cab is provided with front (4) and rear (5) field lights
to improve visibility when working at night. The on/off
switches are in the cab.
Revolving beacon (6)
The revolving beacon is mounted on the front of the cab
roof. As an option, a second revolving beacon can be
mounted on the other side of the cab. Both beacons are
controlled by a switch in the cab.
WARNING: Do not open the windscreen, the doors or
the side and rear windows during work. The noise in
the cab could rise to such level as to oblige the opera-
tor to wear headsets or other individual protection
against noise.
NOTE: See the cab "Maintenance" section for filter use
and maintenance.
To Next Page
Loading...