Tyres, wheels, ballasting
6-23
6
P/N 6525032M1 - X6
Wheel cover stop:
1. End of travel stud
2. Adjuster screw
3. Check nut
Front fender end of travel
To prevent the front fender from colliding with the engine
at the maximum steering angle, the wheel cover rotation
can be stopped while leaving the kingpin free to turn up
to the steering angle.
Screw down the screw (2) onto the stud (1) before the
wheel cover collides with the engine.
Adjustment of max. steering angle
The maximum steering angle for the 4WD front axle can
be changed according to type of tyre and use of the trac-
tor. The angle can be changed adjusting the stop screw
(1) on the housing of the axle final drive.
This adjustment is very useful when operating with mini-
mum track widths to avoid any interferences between tyre
and bonnet.
Maximum steering angle: 55°.
Adjustment of the steering angle:
1. Adjuster screw
2. Screw nut
To Next Page