Tyres, wheels, ballasting
6-11
6
P/N 6525032M1 - X6
WARNING: Always use the specific PPE for the op-
eration concerned.
WARNING: When servicing or making adjust-
ments to the tractor with one set of wheels
supported on a stand, NEVER attempt to ro-
tate the wheel either by hand or by starting
the engine. This could propel the tractor of
the stands. Either support all wheels off the
ground or disconnect the front axle drive
shaft.
IMPORTANT: The steering stops on the axle must be
installed in the correct position for the tread width and
tyre size being used.
WARNING: When you lift up the tractor to
adjust the wheel tracks, follow the directions
for lifting in the Safety Notes section.
WARNING: Maximum attention must be used
when dismounting the front or rear wheels:
because of their weight, a suitable hoist must
be used to remove and handle the wheels.
IMPORTANT:After removing and fitting the wheels back
again, it is important to check the torques of all bolts by
means of a torque wrench at the following intervals:
- First check after 10 work hours.
- Second check after 50 work hours.
- Third check and further checks every 500 work hours.
See the following pages for the driving torques of the front
and rear wheel bolts.
ADJUSTMENT OF TRACK WIDTHS
Important Information For EEC Mem-
ber States
This tractor is manufactured with rear lamps which meet
all lighting regulations for travelling on the public road.
According to the law in force, when travelling on public
roads the distance between the outmost edge of the
tractor and the lens of the rear stop lights must be not
greater than 400 mm - dimension A.
If the track width is set on values greater than the factory
setting, it could be required that the rear lights are repo-
sitioned or that additional lights are installed to comply
with the law in force.
- Overall widths above 3000 mm (118 in) WILL REQUIRE
local authorization for use on the highway. An overall
width of 2550 mm to 2550÷3000 mm (8 to 10 feet)
MAY REQUIRE local authorization for use on the
highway, check before operation.
To Next Page
Loading...