TD 93021US
17 July 2017 / Ver. PF3 48
Installation Guide
teleCARE IP
5.8.8 Connecting the LED Lamp Boards
To connect the LED lamp board, insert the three pins of the LED lamp board into the appropriate three
holes in the back side of the corridor lamp PCB.
Figure 62. Plugging LED lamp board into the corridor lamp PCB
With the three pins inserted and the LED lamp board lined up with the guide marks, firmly press the LED
lamp board into the corridor lamp PCB. Repeat the procedure on the other required LED lamp boards.
Figure 63. Corridor lamp PCB with 4 LED lamp boards
Caution: The pins on the LED lamp board are not in the center of the board so it is important
to make sure that the LED lamp board lines up with the guide marks on the corridor lamp PCB
when the pins are inserted.
Insert the Pins of the LED Lamp Board in
the Holes in the corridor lamp PCB
Align the LED Lamp Board
with the Guide Marks on
the corridor lamp PCB
To Next Page
Loading...
Need help?
General