SmartROC D65 T4F 9 Angle instruments
119 No: 713944459.6 en
!
NOTE: Remember that the desired angle values should always be
specified in relation to the setting of the sight. If the sight is not to
be used, it should be set straight ahead and the desired values ad-
justed to 0.
7.
Drill plan: Mark Drill Plan Handling... in the combo box and confirm with Enter.
8.
Use the arrow key to move to Drillplan action:.
9.
Press enter to see the whole menu.
10.
Select the function with enter.
Load is used to import a drill plan from ROC Manager.
Create is used if a drill plan shall be made in the rig.
To Next Page
Loading...
Need help?
General
