Pset STwrench User Guide
108 (326) 9836 4134 01 Edition 2.9
Torque/angle results:
- If the torque/angle does not exceed the torque/angle limits, the result is taken at the torque
peak or angle peak as specified in the Pset options.
- If the torque/angle goes over the limit, the result is taken as follows:
NOTE: If the angle peak is selected, and the Maximum angle for result search is set to a value
different from zero, the result is taken at the maximum torque in the following interval:
This is applied only if the torque does not exceed the maximum torque and the angle has
Torque peak selected in the Pset options
Angle peak selected in the Pset options
for result search
To Next Page
Loading...
Need help?
General
