STwrench User Guide Working with the QATnode
9836 4134 01 Edition 2.9 259 (326)
18.2.2 QATnode settings
When the STwrench is connected to the QATnode with an IRC-W module, or when the QATnode T is
connected to ToolsNet, the QATnode Settings software (included with the QATnode) allows you to set a
proper IP address suitable for your own network.
The QATnode Settings software CD is provided with all versions of the QATnode. To install the software,
simply insert the installation CD in your computer and follow the installation instructions.
Once installed, the software is shown in the Start → Program Files → Atlas Copco Tools AB →
STwrench Tools menu:
You can connect the PC to the QATnode using a crossed female-female serial cable:
Execute the QATnode Settings software on the PC.
To Next Page
Loading...
Need help?
General
