STwrench User Guide Appendix C – STwrench factory settings
9836 4134 01 Edition 2.9 317 (326)
24 Appendix C - STwrench Factory Settings
The STwrench settings are stored in the RBU. The following table details the RBU default configuration:
Wrench name
This field is left blank in factory settings
Tag enabled
YES
Note that it was set to NO for RBU produced before serial
number RBU P 01156, RBU Q 00170, RBU PA 0010, RBU QA
0016.
Wrench vibration
YES.
Note that it was set to NO for RBU produced before serial
number RBU P 01156, RBU Q 00170, RBU PA 0010, RBU QA
0016.
To Next Page
Loading...
