STwrench User Guide STwrench Settings
9836 4134 01 Edition 2.9 163 (326)
10.2.1.2 Settings STwrench date and time
Date and time device
Date and time appearing on the main menu of the wrench display. This date
and time are associated with the tightening results and traces.
Click on
to align the wrench date and time to the date and time of the
PC connected to the wrench.
Is it possible to enable the automatic synchronization between the date/time
of the STwrench to the current date/time of ToolsTalk BLM and ToolsNet,
by setting the flag Date time synchronization mode.
10.2.1.3 Enabling STwrench tool recognition
Tag enabled
Enables the tool recognition and TAG writer functions on the
STwrench. When enabled, a tightening program is not started unless
an end-fitting tool with RFID TAG is plugged into the smartHEAD.
This is automatically enabled when the Power Focus connection is
activated.
NOTE: If disabled, the torque and angle correction coefficients
possibly defined in the TAG of the end-fitting tool are not considered
during the tightening (see TAG writer). This means that if an
extension is used with TAG disabled, the correction coefficients need
to be specified in the Pset Options).
10.2.1.4 Enabling STwrench vibration device
Device vibration
Enables the vibration device on the STwrench.
This is automatically enabled when the Power Focus connection is
activated.
If enabled, the option Vibrate on NOK results makes the STwrench
vibrate continuously in case of Not OK results, until the OK or CL
button is pressed on the STwrench keyboard, or a new test is started.
To Next Page
Loading...
Need help?
General
