STwrench User Guide Working with the QATnode
9836 4134 01 Edition 2.9 265 (326)
18.3 Printing the Tightening Results on a STAR
printer
This function is provided in all versions of QATnode.
The supported is the STAR DP8340. Refer to the printer manual for printer operation and settings.
NOTE: The serial cable from the QATnode to the printer must be shielded, and not longer than
10 meters.
Ensure that the STwrench is associated with the QATnode; also, ensure that the settings on STwrench and
QATnode are correct as described in the first paragraph of this chapter.
To Next Page
Loading...
