Working with ToolsTalk BLM STwrench User Guide
80 (326) 9836 4134 01 Edition 2.9
5.2.4 Wrench Map
The Wrench Map defines your tightening programs directly on the STwrench; once created, the tightening
programs are automatically transferred to the wrench and stored in the Prog Mode menu:
NOTE: In Prog. Mode, the STwrench reads the RFID TAG of the end-fitting tool (if the
function is enabled in the controller setting). If the torque and/or angle readings are correct in
the Free Mode but incorrect in the Prog. Mode, verify that the torque and angle coefficients of
the end-fitting tool have been set properly. See the chapter TAG writer for more information.
Wrench Map
To Next Page
Loading...
