Working with Power Focus STwrench User Guide
226 (326) 9836 4134 01 Edition 2.9
During the initialization process, the IRC-W icon is shown in four steps:
Module IRC-W detected.
Initial message for connection sent to Power Focus.
Reply received from Power Focus.
Connection active.
When the connection is fully established, the whole logo is displayed:
15.4 Interface with STwrench Cable Box
NOTE
: This connection via cable is not possible with the STwrench Controller BI, but only
with the standard STwrench controller.
Ensure that the STwrench Cable Box is properly installed:
To Next Page
Loading...
