STwrench Settings STwrench User Guide
174 (326) 9836 4134 01 Edition 2.9
10.2.4.5 Trace resolution
In the Common settings, it is possible to select the resolution of the trace sent to Power Focus:
Default value, recommended.
In case the Low setting does not provide the desired accuracy in the trace
displaying, setting this parameters to High multiplies by 6 the number of points in
the trace.
NOTE: Increasing the resolution of the trace slow down a little the performance;
therefore, a delay time is needed to start a new tightening.
10.2.5 IRC-W API settings
This menu permits the operator to configure the IRC-W module for connection to the API. Note that the
configuration can be also done directly from the API. See the chapter Working with the API for details.
To Next Page
Loading...
