STwrench User Guide Working with ToolsTalk BLM
9836 4134 01 Edition 2.9 75 (326)
NOTE: For Windows 7 operating system, at the first usage of the software, right-click on the
ToolsTalk BLM icon and select Run as Administrator to start the software; an error message
may be shown otherwise:
5.1.1 Software registration
After installing the software, you need to register at www.atlascopco.com/tools/software
. If not registered,
the software only works as demo for 60 days.
The registration form can be open from the Start → Atlas Copco Tools AB → ACTLicense menu:
5.1.2 Software upgrade
When upgrading the ToolsTalk BLM software to a new version, simply install the new version. There is
no need to uninstall the previous version.
All STwrench settings, tightening programs and results will remain unaffected by the upgrade process.
To Next Page
Loading...
