Atlas Copco STwrench - Deleting RBU Objects

STwrench User Guide STwrench Settings
9836 4134 01 Edition 2.9 179 (326)
10.2.7.3 Deleting RBU objects
In the Configuration → Reset menu, it is possible to delete objects from the wrench memory:
Delete RBU objects
Deletes all the Psets/Multistages/Jobs (and Type 1 strings of the identifiers) from
the RBU.
NOTE: If the tightening programs are not saved in a .ttb file, performing this
operation will delete all the objects with no chance to restore them later on.
Delete results
Erases all of the results stored in the wrench memory.
Delete Traces
Erases all of the traces stored in the wrench memory.