Atlas Copco STwrench User Manual

STwrench User Guide Working with the QATnode
9836 4134 01 Edition 2.9 253 (326)
18.1.2 IRC-W connection
To establish an IRC-W connection, turn on the STwrench and the QATnode (which must connected to the
access point).
The association is automatically performed between the QATnode and the first STwrench found online.
When the STwrench is associated with the QATnode, the IRC-W logo is shown on the wrench display:
The STwrench and QATnode are now associated.
The IRC-W logo is shown only when the connection is active.
18.1.3 Errors
If the QATnode is already associated with another wrench, the following error message is shown on the
wrench display:
To associate a new wrench to the QATnode, the current association with the old wrench must be disabled
(see the next paragraphs of this chapter for more information).
If the STwrench settings are not compatible with your QATnode type, the following message is shown:

Atlas Copco STwrench Specifications

General

Brand	Atlas Copco
Model	STwrench
Category	Tools
Language	English