Working with the QATnode STwrench User Guide
258 (326) 9836 4134 01 Edition 2.9
Once the settings are completed:
- Click on Store
- Enable the Enable connection with QATnodes.
- Click on Store.
In the Functionality Settings window, set the QATnode type and options:
QATnode Type
Select your QATnode type.
Lock Type
Parameter only valid for IRDA connection, and discarded if an IRC-W connection
is established between the wrench and QATnode.
If one of these flags is enabled, the STwrench must be put on the QATnode at the
end of the Job/Batch/Pset in order to continue with the next tightening program;
this applies only if the source of the tightening program is set to QATnode.
Click on Store to save the settings.
Data rate
Select the data rate. A slower value may help when the communication is not
high-performance.
Power mode
The Sleep mode is recommended for lower power consumption.
Roaming threshold
Select the threshold under which the STwrench will search for a new access
point to connect through.
To Next Page
Loading...
Need help?
General
