Job STwrench User Guide
146 (326) 9836 4134 01 Edition 2.9
During Job execution, the wrench display shows the torque and possibly angle values, and the tightening
direction:
The same information as for the Pset/Multistage execution is displayed, with the following difference:
Pset in execution. When the Pset batch is completed, the next Pset
will be loaded automatically.
The J: 0/2 indicates that the first tightening program (Pset or
Multistage) of the job is being executed.
During Job execution, clicking on the CL button on the wrench key keyboard will skip the ongoing Pset or
Multistage and the batch number will be incremented by one (if the batch size is set to 1, the wrench goes
to the next Pset/Multistage of the Job). If the flag Result of non-tightenings is enabled in the Job option, a
Not OK result is associated with the skipped Pset/Multistage.
NOTE: To avoid skipping a Pset/Multistage by mistake, it is possible to set a warning message
asking for confirmation before skipping. See the Enabling warning message for Job skip
The following summary is displayed at the end of Job execution:
NOTE: Every Pset/Multistage counts as 1 for the number of Results OK and Results NOK,
regardless of the fact that a Multistage may content many Psets, and regardless of the batch
number of each Pset/Multistage in the Job.
For each tightening operation, the LEDs indicator, buzzer and vibration devices are activated according to
the selected tightening strategy.
To Next Page
Loading...
Need help?
General
