Working with Torque Supervisor STwrench User Guide
246 (326) 9836 4134 01 Edition 2.9
Then select the IRC-W API settings menu:
• SSID: Enter the SSID name of your own wireless network.
• IRC-W mode: Select Access Point.
• Host name: Specify a name of the wrench.
• IP Address: Not used.
• Port: Not used.
• Keep alive timeout: Interval between keep alive messages from the wrench; the default value (5
seconds) is recommended.
• Security Type: Select the same security type as your own wireless network.
• Internet Protocol (TCP/IP): Select Static IP, enable the TCP listener, and set the port as in
Torque Supervisor (default value 11000). Enable the Device IP Config (which assigns an IP
address to the STwrench), and set the network parameters. The IP address must match the value
specified in Torque Supervisor.
The Advanced settings... allow you to set the band, channels and parameters for the IRC-W dual band
radio module. Set the following parameters according to your specific radio network and access point:
To Next Page
Loading...
Need help?
General
