Atlas Copco STwrench - Page 324

Abbreviations STwrench User Guide
324 (326) 9836 4134 01 Edition 2.9
S
Safety; 11
Save
save offline programs to STwrench; 84
save tightening programs from STwrench; 79
Sensitivity; 179
Serial number; 167
Settings; 158
automatic shutdown; 164
batch increment options; 163
batch mode; 163
buzzer; 162
CCA procedure from wrench menu; 158
controller setup; 159
date and time; 161
date format; 165
enabling Pset/MS/Job grouping in Prog. Mode; 162
enabling warning message for Job skip; 162
Erasing memory data; 177
free mode enabling; 162
general display timeout; 164
illuminating light; 162
LEDs; 173
minimum load default value; 176
Power Focus; 168
real time traces; 204
result confirmation; 163
results fields; 166
settings menu on wrench enabling; 162
source of Pset and Multistage; 164
STwrench date and time; 161
STwrench factory configuration; 305; 307
STwrench menu language setup; 158; 165
STwrench name; 160
tool recognition; 161
ToolsNet; 167
ToolsTalk BLM language setup; 80
traces settings; 175
vibration device; 161
wrench name; 160
Shock indicator
maintenance; 293
troubleshooting; 297
smartHEAD; 40
angle correction coefficient; 180
calibration value; 179
capacity; 180
information; 179
installation; 42
last calibration date; 180
last overload; 180
min. load; 179
serial number; 179
Snug point; 120
Software. See ToolsTalk BLM
Software upgrade; 73
Span; 179
Specifications; 16
Barcode reader; 19
battery; 16
battery charger; 17
dimensions; 17
environmental; 20
interfaces; 18
IRC-B radio; 18
IRC-W radio; 18
IRC-Z radio; 19
QATnode; 19
RFID; 20
standard conformity; 21
System Requirements; 20
technical; 16
weight; 17
Standard conformity; 21
STAR printer
configuring the report; 257
printing tightening results; 255
Start final angle; 91
Status bar; 77
STwrench name; 160
Sub source job; 165
System requirements; 20
T
TAG writer; 181
torque and angle correction coefficients for end fitting
tool; 182
Tightening direction; 95
Tightening strategies
loose; 118
loose and retight; 135
PVT compensate with snug point; 119
residual Torque/Angle; 127
residual Torque/Peak; 133
residual Torque/Time; 123
selecting strategy for a Pset; 87
torque; 102
Torque (control) / Angle (control) AND; 112
Torque (control) / Angle (control) OR; 109
Torque (control) / Angle (monitor); 104
Torque (monitor) / Angle (control); 106
Yield point (production); 114
Yield Point (Quality); 122
Timeout; 92
Tool
toolbar; 76