STwrench User Guide Working with ToolsTalk BLM
9836 4134 01 Edition 2.9 73 (326)
If the software is installed without a STwrench connected, at the end of the installation, the user will be
required to connect a STwrench to the PC to continue with driver installation:
Turn on the STwrench and wait until initialization has finished and the main menu is shown on the wrench
display. When you connect the STwrench to the PC via the USB cable, the new hardware setup wizard
will start:
Select No, not this time, and click on Next
Select Install the software automatically, and click on Next.
To Next Page
Loading...
Need help?
General
