User's Manual 1056 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
62.10.5.4 Message Waiting Indication Parameters
The message waiting indication (MWI) parameters are described in the table below.
Table 62-45: MWI Parameters
Parameter Description
Enable MWI
configure voip > gateway dtmf-
supp-service supp-service-
settings > enable-mwi
[EnableMWI]
Enables Message Waiting Indication (MWI).
 [0] Disable (default)
 [1] Enable
Note:
 The parameter is applicable only to FXS interfaces.
 The device supports only the receipt of SIP MWI NOTIFY
messages (the device doesn't generate these messages).
 For more information on MWI, see ''Message Waiting
Indication'' on page 547.
MWI Analog Lamp
configure voip > gateway dtmf-
supp-service supp-service-
settings > mwi-analog-lamp
[MWIAnalogLamp]
Global parameter enabling the visual display of MWI.
You can also configure the functionality per specific calls, using
Tel Profiles (TelProfile_MWIAnalog). For a detailed description of
the parameter and for configuring the functionality in the Tel
Profiles table, see ''Configuring Tel Profiles'' on page 428.
Note:
 If the functionality is configured for a specific Tel Profile, the
settings of the global parameter is ignored for calls associated
with the Tel Profile.
 The parameter is applicable only to FXS interfaces.
MWI Display
configure voip > gateway dtmf-
supp-service supp-service-
settings > enable-mwi
[MWIDisplay]
Global parameter enabling the sending of MWI information to the
phone display.
You can also configure the functionality per specific calls, using
Tel Profiles (TelProfile_MWIDisplay). For a detailed description of
the parameter and for configuring the functionality in the Tel
Profiles table, see ''Configuring Tel Profiles'' on page 428.
Note:
 If the functionality is configured for a specific Tel Profile, the
settings of the global parameter is ignored for calls associated
with the Tel Profile.
 The parameter is applicable only to FXS interfaces.
Subscribe to MWI
configure voip > gateway dtmf-
supp-service supp-service-
settings > subscribe-to-mwi
[EnableMWISubscription]
Enables subscription to an MWI server.
 [0] No (default)
 [1] Yes
Note:
 To configure the MWI server address, use the MWIServerIP
parameter.
 To configure whether the device subscribes per endpoint or
per the entire device, use the parameter SubscriptionMode.
MWI Server IP Address
configure voip > gateway dtmf-
supp-service supp-service-
settings > mwi-srvr-ip-addr
[MWIServerIP]
Defines the MWI server's IP address. If provided, the device
subscribes to this IP address. The MWI server address can be
configured as a numerical IP address or as a domain name. If not
configured, the Proxy IP address is used instead.
To Next Page
Loading...
Need help?
General
