AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 837 Mediant 1000B Gateway & E-SBC
User's Manual 54. Reporting Information to External Party
54 Reporting Information to External Party
This section describes features for reporting various information to an external party.
54.1 Configuring RTCP XR
RTP Control Protocol Extended Reports (RTCP XR) is a VoIP management control that
defines a set of metrics containing information for assessing VoIP call quality and for
diagnosing problems. RTCP XR (RFC 3611) extends the RTCP reports defined in RFC
3550 by providing additional VoIP metrics (Quality of Experience). RTCP XR information
publishing is implemented in the device according to RFC 6035. This draft defines how a
SIP User Agent (UA) publishes the detailed information to a defined collector. RTCP XR
measures VoIP call quality such as packet loss, delay, signal / noise / echo levels,
estimated R-factor, and mean opinion score (MOS). RTCP XR measures these parameters
using metrics as listed in the table below. RTCP XR messages containing key call-quality-
related metrics are exchanged periodically (user-defined) between the device and the SIP
UA. This allows an analyzer to monitor these metrics midstream, or a device to retrieve
them through SNMP.
Note:
• The RTCP XR feature is available only if the device is installed with a License Key
that includes this feature. For installing a License Key, see ''License Key'' on page
763.
• If the RTCP XR feature is unavailable (not licensed or disabled), the R-factor VoIP
metrics are not provided in CDRs (CDR fields, Local R Factor and Remote R
Factor) generated by the device. Instead, these CDR fields are sent with the value
127, meaning that information is unavailable.
You can configure the device to send RTCP XR to a specific IP Group. In addition, you can
configure the stage of the call at which you want the device to send RTCP XR:

End of the call.

Periodically, according to a user-defined interval between consecutive reports.

(Gateway Application Only) End of a media segment. A media segment is a change in
media, for example, when the coder is changed or when the caller toggles between
two called parties (using call hold/retrieve). The RTCP XR sent at the end of a media
segment contains information only of that segment. For call hold, the device sends
RTCP XR each time the call is placed on hold and each time it is retrieved. In addition,
the Start timestamp in the RTCP XR indicates the start of the media segment; the End
timestamp indicates the time of the last sent periodic RTCP XR (typically, up to 5
seconds before reported segment ends).
The device sends RTCP XR in SIP PUBLISH messages. The PUBLISH message contains
the following RTCP XR related header values:

From and To: Telephone extension number of the user

Request-URI: IP Group to where RTCP XR is sent

Event: "vq-rtcpxr"

Content-Type: "application/vq-rtcpxr"
The type of RTCP XR report event (VQReportEvent) supported by the device is
VQSessionReport (SessionReport). The device can include local and remote metrics in the
RTCP XR. Local metrics are generated by the device while remote metrics are provided by

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English