User's Manual 654 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
[Classification_IpProfileNam
e]
Group (in the IP Groups table) to which the SIP dialog is classified.
Therefore, assigning an IP Profile during classification allows you to
assign different IP Profiles to specific users (calls) that belong to the
same IP Group (User or Server type).
For example, you can configure two Classification rules to classify
incoming calls to the same IP Group. However, one Classification rule
is a regular rule that doesn't specify any IP Profile (IP Profile assigned
to IP Group is used), while the second rule is configured with an
additional matching characteristic for the source hostname prefix (e.g.,
"abcd.com") and with an additional action that assigns a different IP
Profile.
By default, no value is defined.
Note: For User-type IP Groups, if a user is already registered with the
device (from a previous, initial classification process), the device
classifies subsequent INVITE requests from the user according to the
device's users database instead of the Classification table. In such a
scenario, the same IP Profile that was previously assigned to the user
by the Classification table is also used (in other words, the device's
users database stores the associated IP Profile).
33.1.1 Classification Based on URI of Selected Header Example
The following example describes how to configure classification of incoming calls to IP
Groups, based on source URI in a specific SIP header. The example assumes the
following incoming INVITE message:
INVITE sip:8000@10.33.4.226 SIP/2.0
Via: SIP/2.0/UDP 10.33.4.226;branch=z9hG4bKVEBTDAHSUYRTEXEDEGJY
From: <sip:100@10.33.4.226>;tag=YSQQKXXREVDPYPTNFMWG
To: <sip:8000@10.33.4.226>
Call-ID: FKPNOYRNKROIMEGBSSKS@10.33.4.226
CSeq: 1 INVITE
Contact: <sip:100@10.33.4.226>
Route: <sip:2000@10.10.10.10.10>,<sip:300@10.10.10.30>
Supported: em,100rel,timer,replaces
P-Called-Party-ID: <sip:1111@10.33.38.1>
User-Agent: Sip Message Generator V1.0.0.5
Content-Length: 0
1. In the Classification table, add the following classification rules:
Index
Source Username
Prefix
Destination
Username Prefix
Destination Host Source IP Group
0 333 - - 1
1 1111 2000 10.10.10.10 2
1. In the IP Groups table, add the following IP Groups:
Index Source URI Input Destination URI Input
1 - -
To Next Page
Loading...
Need help?
General
