Version 7.2 1071 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description

This is parameter is applicable only to FXS and FXO interfaces.
 For a detailed description of the table, see ''Configuring Automatic
Dialing'' on page 581.
62.10.5.12 Direct Inward Dialing Parameters
The Direct Inward Dialing (DID) parameters are described in the table below.
Table 62-53: DID Parameters
Parameter Description
DID Wink
configure voip > sip-
definition settings > did-
wink-enbl
[EnableDIDWink]
Global parameter enabling Direct Inward Dialing (DID) using Wink-Start
signaling, typically used for signaling between an E-911 switch and the
PSAP.
You can also configure the functionality per specific calls, using Tel
Profiles (TelProfile_EnableDIDWink). For a detailed description of the
parameter and for configuring the
functionality in the Tel Profiles table, see
''Configuring Tel Profiles'' on page 428.
Note:
 The parameter is applicable to FXS and FXO interfaces.
 If the functionality is configured for a specific Tel Profile, the settings of
the global parameter is ignored for calls associated with the Tel Profile.
configure voip > sip-
definition settings > time-
between-did-winks
[TimeBetweenDIDWinks]
Defines the interval (in msec) for wink signaling:
 Double-wink signaling [2]: interval between the first and second wink
 Wink and Polarity signaling [3]: interval between wink and polarity
change
The valid range is 100 to 2000. The default is 1000.
Note: See the EnableDIDWink parameter for configuring the wink
signaling type.
Delay Before DID Wink
configure voip > sip-
definition settings >
delay-b4-did-wink
[DelayBeforeDIDWink]
Defines the time interval (in msec) between the detection of the off-hook
and the generation of the DID Wink.
The valid range is 0 to 1,000. The default is 0.
Note: The parameter is applicable only to FXS interfaces.
NTT-DID-signaling-form
[NTTDIDSignallingForm]
Determines the type of DID signaling support for NTT (Japan) modem:
DTMF- or Frequency Shift Keying (FSK)-based signaling. The devices can
be connected to Japan's NTT PBX using 'Modem' DID lines. These DID
lines are used to deliver a called number to the PBX.
 [0] = (Default) FSK-based signaling
 [1] = DTMF-based signaling
Note: The parameter is applicable only to FXS interfaces.
configure voip > sip-
definition settings >
enable-did
[EnableDID]
This table parameter enables support for Japan NTT 'Modem' DID. FXS
interfaces can be connected to Japan's NTT PBX using 'Modem' DID
lines. These DID lines are used to deliver a called number to the PBX. The
DID signal can be sent alone or combined with an NTT Caller ID signal.
The format of the ini file table parameter is as follows:
[EnableDID]
FORMAT EnableDID_Index = EnableDID_IsEnable; EnableDID_Port,
To Next Page
Loading...
Need help?
General
