Version 7.2 273 Mediant 1000B Gateway & E-SBC
User's Manual 15. Services
Phones register with the device in order to allow communication between the IP
Phones and the EMS.
To support the functionality, the following configuration is required:
1. Enable the HTTP Proxy application (see ''Enabling the HTTP Proxy Application''
on page 273).
2. Configure two local, listening HTTP interfaces - one for the EMS and one for the
IP Phones (see ''Configuring HTTP Interfaces'' on page 273).
3. Configure the address of the EMS server (see ''Configuring an HTTP-based EMS
Service'' on page 278).
15.6.1 Enabling the HTTP Proxy Application
Before you can configure HTTP-based proxy services, you must enable the HTTP Proxy
application, as described in the following procedure. Once enabled, the Web interface
displays menus in the Navigation pane that are relevant to the HTTP Proxy application.
Note: The HTTP Proxy application is a license-dependent feature and is available
only if it is included in the License Key installed on the device. For ordering the
feature, please contact your AudioCodes sales representative. For installing a new
License Key, see License Key on page 763.
 To enable the HTTP Proxy application:
1. Open the General Settings page (Setup menu > IP Network tab > HTTP Proxy folder
> General Settings).
Figure 15-47: Enabling HTTP Proxy Application
2. From the 'HTTP Proxy Application' drop-down list, select Enable.
3. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
15.6.2 Configuring HTTP Interfaces
The HTTP Interfaces table lets you configure up to 10 HTTP Interfaces. An HTTP Interface
represents a local, listening interface for receiving HTTP/S requests from HTTP-based
(Web) clients such as managed equipment (e.g., IP Phones) and/or AudioCodes EMS
management tool for HTTP/S-based services.
The following procedure describes how to configure HTTP Interfaces through the Web
interface. You can also configure it through ini file (HTTPInterface) or CLI (configure
network > http-proxy http-interface).
 To configure an HTTP Interface:
1. Open the HTTP Interfaces table (Setup menu > IP Network tab > HTTP Proxy folder
> HTTP Interfaces).
To Next Page
Loading...
Need help?
General
