User's Manual 220 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
3. Click New; the following dialog box appears:
Figure 15-4: DHCP Static IP Table - Add Dialog Box
4. Configure a static IP address for a specific DHCP client according to the parameters
described in the table below.
5. Click Apply.
Table 15-5: DHCP Static IP Table Parameter Descriptions
Parameter Description
Index
dhcp static-ip <index>
[DhcpStaticIP_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
DHCP Server Index
dhcp-server-number
[DhcpStaticIP_DhcpServerIndex]
Associates the DHCP Static IP table entry with a DHCP server
that you configured in ''Configuring the DHCP Server'' on page
211.
Note: Currently, only one DHCP server (Index 0) can be
configured and therefore, the parameter is always set at 0.
IP Address
ip-address
[DhcpStaticIP_IPAddress]
Defines the "reserved", static IP address (IPv4) to assign the
DHCP client.
The default is 0.0.0.0.
MAC Address
mac-address
[DhcpStaticIP_MACAddress]
Defines the DHCP client by MAC address (in hexadecimal format).
The valid value is a string of up to 20 characters. The format
includes six groups of two hexadecimal digits, each separated by
a colon. The default MAC address is 00:90:8f:00:00:00.
15.1.5 Viewing and Deleting DHCP Clients
The DHCP Clients table lets you view currently serviced DHCP clients by the DHCP
server. The table also lets you delete DHCP clients. If you delete a client, the DHCP server
ends the lease of the IP address to the client and the IP address becomes available for
allocation by the DHCP server to another client.
The following procedure describes how to view DHCP clients through the Web interface.
You can also view this through CLI:
To view DHCP clients:
To Next Page
Loading...
Need help?
General
