AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 139 Mediant 1000B Gateway & E-SBC
User's Manual 12. Network
12.5.1 Assigning NTP Services to Application Types
You can associate the Network Time Protocol (NTP) application with the OAMP or Control
application type. This is done using the EnableNTPasOAM ini file parameter. For more
information on NTP, see ''Configuring Automatic Date and Time using SNTP'' on page 119.
12.5.2 IP Interfaces Table Configuration Guidelines
Adhere to the following guidelines when configuring network interfaces in the IP Interfaces
table:

Multiple Control and Media interfaces can be configured with overlapping IP
addresses and subnets.

The prefix length replaces the dotted-decimal subnet mask presentation and must
have a value of 0-30 for IPv4 addresses and a value of 0-64 for IPv6 addresses.

One OAMP interface must be configured and this must be an IPv4 address. This
OAMP interface can be combined with Media and Control.

At least one Control interface must be configured.

At least one Media interface must be configured.

Multiple Media and/or Control interfaces can be configured with an IPv6 address.

The network interface types can be combined:
• Example 1:
♦ One combined OAMP-Media-Control interface with an IPv4 address
• Example 2:
♦ One OAMP interface with an IPv4 address
♦ One or more Control interfaces with IPv4 addresses
♦ One or more Media interfaces with IPv4 interfaces
• Example 3:
♦ One OAMP with an IPv4 address
♦ One combined Media-Control interface with IPv4 address
♦ One combined Media-Control interface with IPv6 address

Each network interface can be configured with a Default Gateway. The address of the
Default Gateway must be in the same subnet as the associated interface. Additional
static routing rules can be configured in the Static Routes table.

The interface name must be configured (mandatory) and must be unique for each
interface.

Each network interface must be assigned an Ethernet Device.

For IPv4 addresses, the 'Interface Mode' column must be set to IPv4 Manual. For IPv6
addresses, this column must be set to IPv6 Manual or IPv6 Manual Prefix.
Note:
Upon device start up, the IP Interfaces table is parsed and passes
comprehensive validation tests. If any errors occur during this validation phase, the
device sends an error message to the Syslog server and falls back to a "safe mode",
using a single interface without VLANs. Ensure that you view the Syslog messages
that the device sends in system startup to see if any errors occurred.

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English