User's Manual 1072 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
[\EnableDID]
Where,

 IsEnable = Enables [1] or disables [0] (default) Japan NTT Modem DID
support.
 Port = Port number.
 Module = Module number.
For example:
EnableDID 0 = 1,1,2; (DID is enabled on Port 1 of Module 2)
Note: The parameter is applicable only to FXS interfaces.
configure voip >
interface fxs-fxo > wink-
time
[WinkTime]
Defines the time (in msec) elapsed between two consecutive polarity
reversals. The parameter can be used for DID signaling, for example,
E911 lines to the Public Safety Answering Point (PSAP), according to the
Bellcore GR-350-CORE standard (refer to the ini file parameter
Enable911PSAP).
The valid range is 0 to 4,294,967,295. The default is 200.
Note: For the parameter to take effect, a device reset is required.
62.10.5.13 ISDN BRI Parameters
The ISDN BRI call forwarding service parameters are described in the table below.
Table 62-54: BRI Call Forwarding Services Parameters
Parameter Description
BRI-to-SIP Supplementary Services Codes for Call Forward
For more information, see ''BRI Call Forwarding'' on page 544.
Call Forward Unconditional
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-code
[SuppServCodeCFU]
Defines the prefix code for activating Call Forward Unconditional sent
to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward Unconditional
Deactivation
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfu-
deactivation-code
[SuppServCodeCFUDeact]
Defines the prefix code for deactivating Call Forward Unconditional
Deactivation sent to the softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on Busy
configure voip >
gateway dtmf-supp-
service supp-service-
settingscfb-code
[SuppServCodeCFB]
Defines the prefix code for activating Call Forward on Busy sent to the
softswitch.
The valid value is a string. By default, no value is defined.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
To Next Page
Loading...
Need help?
General
