AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 467 Mediant 1000B Gateway & E-SBC
User's Manual 22. Trunk Groups
Parameter Description
Trunk Group ID
trunk-group-id
[TrunkGroup_TrunkGroupNum]
Defines the Trunk Group ID for the specified channels. The same
Trunk Group ID can be assigned to more than one group of
channels. If an IP-to-Tel call is assigned to a Trunk Group, the IP
call is routed to the channel(s) pertaining to that Trunk Group ID.
The valid value can be 0 to 119.
Tel Profile Name
tel-profile-id
[TrunkGroup_ProfileName]
Assigns a Tel Profile to the Trunk Group.
To configure Tel Profiles, see ''Configuring Tel Profiles'' on page
428.
22.2 Configuring Trunk Group Settings Table
The Trunk Group Settings table lets you configure various settings per Trunk Group which
are configured in Configuring Trunk Groups on page 465. The main configuration includes
the following:

Channel select method, which defines how the device allocates incoming IP-to-Tel
calls to the channels of a Trunk Group.

Registration method for registering Trunk Groups to remote IP servers (Serving IP
Group).
The Trunk Group Settings table also provides an Action drop-down button with commands
that let you perform various actions per configured Trunk Group:

Lock / Unlock: Locks (blocks) a Trunk Group in order to take its member trunks out-
of-service. For more information, see ''Locking and Unlocking Trunk Groups'' on page
734.

Register / Un-Register: Initiates a registration request for the Trunk Group with a
Serving IP Group. For more information, see the description of the 'Registration Mode'
parameter of the Trunk Group Settings table in this section.
The following procedure describes how to configure settings for Trunk Groups through the
Web interface. You can also configure it through ini file (TrunkGroupSettings) or CLI
(configure voip/gw hunt-or-trunk-group trunk-group-setting).
 To configure Trunk Group settings:
1. Open the Trunk Group Settings table (Setup menu > Signaling & Media tab >
Gateway folder > Trunks & Groups > Trunk Group Settings).
2. Click New; the following dialog box appears:

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English