AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 1109 Mediant 1000B Gateway & E-SBC
User's Manual 62. Configuration Parameters Reference
Parameter Description
Release Cause Mapping
Table
configure voip > gateway
manipulation
CauseMapIsdn2Sip
[CauseMapISDN2SIP]
This table parameter maps ISDN Q.850 Release Causes to SIP
responses. The format of the ini file table parameter is as follows:
[CauseMapISDN2SIP]
FORMAT CauseMapISDN2SIP_Index =
CauseMapISDN2SIP_IsdnReleaseCause,
CauseMapISDN2SIP_SipResponse;
[\CauseMapISDN2SIP]
Release Cause Mapping from SIP to ISDN Table
Release Cause Mapping
Table
configure voip > gateway
manipulation
CauseMapSip2Isdn
[CauseMapSIP2ISDN]
This table parameter maps SIP responses to Q.850 Release Causes.
The format of the ini file table parameter is as follows:
[CauseMapSIP2ISDN]
FORMAT CauseMapSIP2ISDN_Index =
CauseMapSIP2ISDN_SipResponse,
CauseMapSIP2ISDN_IsdnReleaseCause;
[\CauseMapSIP2ISDN]
ISDN-to-ISDN Release Cause Code Conversion Table
Release Cause ISDN > ISDN
configure voip > gateway
manipulation cause-map-
isdn2isdn
[CauseMapIsdn2Isdn]
Defines ISDN-to-ISDN release cause code mapping rules.
The format of the ini file table parameter is as follows:
[ CauseMapIsdn2Isdn ]
FORMAT CauseMapIsdn2Isdn_Index =
CauseMapIsdn2Isdn_OrigIsdnReleaseCause,
CauseMapIsdn2Isdn_MapIsdnReleaseCause;
[ \CauseMapSip2Isdn ]
For a detailed description of this table, see ''Configuring ISDN-to-
ISDN Release Cause Mapping'' on page 526.
62.10.8 Answer and Disconnect Supervision Parameters
The answer and disconnect supervision parameters are described in the table below.
Table 62-61: Answer and Disconnect Parameters
Parameter Description
Wait before PSTN Release-Ack
wait-befor-pstn-rel-ack
[TimeToWaitForPstnReleaseAck]
Defines a timeout (in milliseconds) that the device waits for
the receipt of an ISDN Q.931 Release message from the
PSTN side before releasing the channel. The Release ACK is
typically sent by the PSTN in response to the device's
Disconnect message to end the call. If the timeout expires and
a Release message has not yet been received, the device
releases the call channel.
The valid value is 1 to 360,000. The default is 6,000.
Note: The parameter is applicable only to digital interfaces.
Answer Supervision
configure voip > gateway analog fxo-
setting > answer-supervision
[EnableVoiceDetection]
Enables the sending of SIP 200 OK upon detection of speech,
fax, or modem.
 [1] Yes = The device sends a SIP 200 OK (in response to
an INVITE message) when speech, fax, or modem is
detected (from the Tel side, for analog interfaces).
 [0] No = (Default) The device sends a SIP 200 OK only

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English