User's Manual 928 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
62.1.2 Web Parameters
The Web parameters are described in the table below.
Table 62-2: Web Parameters
Parameter Description
Enable web access from all interfaces
web-access-from-all-interfaces
[EnableWebAccessFromAllInterfaces]
Enables Web access from any of the device's IP network
interfaces. The feature applies to HTTP and HTTPS
protocols.
 [0] = (Default) Disable – Web access is only through the
OAMP interface.
 [1] = Enable - Web access is through any network
interface.
Password Change Interval
[WebUserPassChangeInterval]
Defines the duration (in minutes) of the validity of Web login
passwords. When this duration expires, the password of the
Web user must be changed.
The valid value is 0 to 100000, where 0 means that the
password is always valid. The default is 1140.
Note: The parameter is applicable only when using the
Local Users table, where the default value of the 'Password
Age' parameter in the Local Users table inherits the
parameter's value.
User Inactivity Timer
[UserInactivityTimer]
Defines the duration (in days) for which a user has not
logged in to the Web interface, after which the status of the
user becomes inactive and can no longer access the Web
interface. These users can only log in to the Web interface if
their status is changed (to New or Valid) by a Security
Administrator or Master user.
The valid value is 0 to 10000, where 0 means inactive. The
default is 90.
Note: The parameter is applicable only when using the
Local Users table.
Session Timeout
[WebSessionTimeout]
Defines the duration (in minutes) of inactivity of a logged-in
user in the Web interface, after which the user is
automatically logged off the Web session. In other words,
the session expires when the user has not performed any
operations (activities) in the Web interface for the configured
duration.
The valid value is 0-
100000, where 0 means no timeout. The
default is 15.
Note:
You can also configure the functionality per user in the
Local Users table (see ''Configuring Management User
Accounts'' on page
65), which overrides this global setting.
Deny Access On Fail Count
[DenyAccessOnFailCount]
Defines the maximum number of failed login attempts, after
which the requesting IP address is blocked.
The valid value range is 0 to 10. The values 0 and 1 mean
immediate block. The default is 3.
Deny Authentication Timer
[DenyAuthenticationTimer]
Defines the duration (in seconds) for which login to the Web
interface is denied from a specific IP address (for all users)
when the number of failed login attempts has exceeded the
maximum. This maximum is defined by the
DenyAccessOnFailCount parameter. Only after this time
To Next Page
Loading...
Need help?
General
