AudioCodes MediaPack MP-11 Series User Manual

User's Manual 1082 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
1.
Auto Clock Trunk Priority
configure voip > interface e1-t1|bri > clock-
priority clock-priority
[AutoClockTrunkPriority]
Defines the trunk priority for auto-clock fallback (per
trunk parameter).
The valid range is 0 to 100, where 0 (default) is the
highest priority and 100 indicates that the device does
not perform a fallback to the trunk (typically, used to
mark untrusted source of clock).
Note: Fallback is enabled when the
TDMBusPSTNAutoClockEnable parameter is set to 1.
62.10.6.3 CAS Parameters
The Common Channel Associated (CAS) parameters are described in the table below.
Note: CAS is applicable only to ISDN PRI interfaces.
Table 62-58: CAS Parameters
Parameter Description
CAS Transport Type
cas-transport-type
[CASTransportType]
Determines the ABCD signaling transport type over IP.
 [0] CAS Events Only = (Default) Disable CAS relay.
 [1] CAS RFC2833 Relay = Enable CAS relay mode using
RFC 2833.
The CAS relay mode can be used with the TDM tunneling feature
to enable tunneling over IP for both voice and CAS signaling
bearers.
[CASAddressingDelimiters] Enables the addition of delimiters to the received address or
received ANI digits string.
 [0] = (default) Disable. The address and ANI strings remain
without delimiters.
 [1] = Enable. Delimiters such as '*', '#', and 'ST' are added to
the received address or received ANI digits string.
configure voip > interface e1-t1 >
cas-delimiters-types
[CASDelimitersPaddingUsage]
Defines the digits string delimiter padding usage per trunk.
 [0] = (Default) Default address string padding: '*XXX#' (where
XXX is the digit string that begins with '*' and ends with '#',
when using padding).
 [1] = Special use of asterisks delimiters: '*XXX*YYY*' (where
XXX is the address, YYY is the source phone number, and '*'
is the only delimiter padding).
Note: For the parameter to take effect, a device reset is required.
CAS Table per Trunk
configure voip > interface e1-t1 >
cas-table-index
[CASTableIndex_x]
Defines the CAS protocol per trunk from a list of CAS protocols
defined by the parameter CASFileName_x.
For example, the below configuration specifies Trunks 0 and 1 to
use the E&M Winkstart CAS (E_M_WinkTable.dat) protocol, and
Trunks 2 and 3 to use the E&M Immediate Start CAS

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English