Version 7.2 719 Mediant 1000B Gateway & E-SBC
User's Manual 39. CRP Configuration
39 CRP Configuration
This section describes configuration specific to the CRP application. As CRP has similar
functionality to the SBC application, for configuration that is common to the SBC, which is
not covered in this section, see the following SBC sections:
''Configuring Admission Control'' on page 643
''Configuring Allowed Audio Coder Groups'' on page 389
''Configuring Classification Rules'' on page 647
''Configuring Message Condition Rules'' on page 655
''Configuring SBC IP-to-IP Routing Rules'' on page 656
''Configuring SIP Response Codes for Alternative Routing Reasons'' on page 668
''Configuring IP-to-IP Inbound Manipulations'' on page 679
''Configuring IP-to-IP Outbound Manipulations'' on page 683
Note: The main difference in the common configuration between the CRP and SBC
applications is the navigation menu paths to opening these Web configuration pages.
Wherever "SBC" appears in the menu path, for the CRP application it appears as
"CRP".
39.1 Enabling the CRP Application
Before you can start configuring the CRP, you must first enable the CRP application. Once
enabled, the Web interface displays the menus and parameter fields relevant to the CRP
application.
Note: The CRP feature is available only if the device is installed with a License Key
that includes this feature. For installing a License Key, see ''License Key'' on page
763.
To enable the CRP application:
1. Open the Applications Enabling page (Setup menu > Signaling & Media tab > Core
Entities folder > Applications Enabling).
2. From the 'CRP Application' drop-down list, select Enable.
3. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
39.2 Configuring Call Survivability Mode
The CRP can be configured to operate in one of the following call survivability modes:
To Next Page
Loading...
Need help?
General
