User's Manual 1186 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
Parameter Description
HTTPProxyService_URLPrefix, HTTPProxyService_KeepAliveMode;
[ \HTTPProxyService ]
For a description of the table, see ''Configuring HTTP Proxy
Services'' on page 275.
HTTP Proxy Hosts Table
HTTP Proxy Hosts
configure network >
http-proxy http-proxy-
host
[HTTPProxyHost]
Defines HTTP Proxy hosts. The table is a "child" of the HTTP Proxy
Services table (HTTPProxyService). An HTTP Proxy Host represents
the HTTP-based managed equipment (e.g., IP Phone).
The format of the ini file table parameter is as follows:
[ HTTPProxyHost ]
FORMAT HTTPProxyHost_Index =
HTTPProxyHost_HTTPProxyServiceId,
HTTPProxyHost_HTTPProxyHostId,
HTTPProxyHost_NetworkInterface, HTTPProxyHost_IpAddress,
HTTPProxyHost_Protocol, HTTPProxyHost_Port,
HTTPProxyHost_TLSContext, HTTPProxyHost_VerifyCert;
[ \HTTPProxyHost ]
For a description of the table, see ''Configuring HTTP Proxy Hosts''
on page 276.
EMS Services Table
EMS Services
configure network >
http-proxy ems-serv
[EMSService]
Defines an HTTP-based EMS Service so that the device can act as
an HTTP Proxy that enables AudioCodes EMS to manage
AudioCodes equipment (such as IP Phones) over HTTP when the
equipment is located behind NAT (e.g., in the LAN) and EMS is
located in a public domain (e.g., in the WAN).
The format of the ini file table parameter is as follows:
[ EMSService ]
FORMAT EMSService_Index = EMSService_ServiceName,
EMSService_PrimaryServer, EMSService_SecondaryServer,
EMSService_DeviceLoginInterface, EMSService_EMSInterface;
[ \EMSService ]
For a description of the table, see ''Configuring an HTTP-based EMS
Service'' on page 278.
To Next Page
Loading...
Need help?
General
