AudioCodes MediaPack MP-11 Series User Manual

Version 7.2 567 Mediant 1000B Gateway & E-SBC
User's Manual 26. Configuring Supplementary Services
 To register or un-register an endpoint:
1. In the Trunk Group Settings table (see ''Configuring Trunk Group Settings'' on page
467), configure the registration method using the 'Registration Mode' parameter.
2. In the Supplementary Services table, select the required endpoint.
3. From the 'Action' drop-down list, select Register. To unregister the endpoint, select
Un-Register.
Table 26-6: Supplementary Services Table Parameter Description
Parameter Description
General
Index
[ISDNSuppServ_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Global Phone Number
phone-number
[ISDNSuppServ_PhoneNumber]
Defines a global telephone extension number for the endpoint.
The global number is used for the following functionalities:
 Endpoint registration
 IP-to-Tel routing
 Mapping between local and global (E.164) numbers between
Tel and IP sides respectively
Local Phone Number
local-phone-number
[ISDNSuppServ_LocalPhoneNu
mber]
Defines a local telephone extension number for the endpoint
(e.g., the PBX extension number). The local number is used for
the following functionalities:
 Validation of source (calling) number for Tel-to-IP calls
 Mapping between local and global (E.164) numbers between
Tel and IP sides respectively
Module
module
[ISDNSuppServ_Module]
Defines the device's module number to which the endpoint is
connected.
Port
port
[ISDNSuppServ_Port]
Defines the port number on the module to which the endpoint is
connected.
User ID
user-id
[ISDNSuppServ_UserId]
Defines the User ID for registering the endpoint to a third-party
softswitch for authentication and/or billing.
User Password
user-password
[ISDNSuppServ_UserPassword]
Defines the user password for registering the endpoint to a third-
party softswitch for authentication and/or billing.
Note: For security, the password is displayed as an asterisk (*).
Caller ID
Caller ID Enabled
caller-id-enable
[ISDNSuppServ_IsCallerIDEnabl
ed]
Enables the receipt of Caller ID.
 [0] Disabled = The device does not send Caller ID information
to the endpoint.
 [1] Enabled = The device sends Caller ID information to the
endpoint.
Caller ID Name
caller-id-number
Defines the caller ID name of the endpoint (sent to the IP side).
The valid value is a string of up to 18 characters.

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English