AudioCodes MediaPack MP-11 Series User Manual

User's Manual 684 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
 To configure Outbound Manipulation rules:
1. Open the Outbound Manipulations table (Setup menu > Signaling & Media tab >
SBC folder > Manipulation > Outbound Manipulations).
2. Click New; the following dialog box appears:
Figure 34-3: Outbound Manipulations Table- Add Dialog Box
3. Configure an Outbound Manipulation rule according to the parameters described in
the table below.
4. Click Apply.
Table 34-2: Outbound Manipulations Table Parameter Description
Parameter Description
Routing Policy
routing-policy-name
[IPOutboundManipulation_Ro
utingPolicyName]
Assigns a Routing Policy to the rule. The Routing Policy associates
the rule with an SRD(s). The Routing Policy also defines de
fault LCR
settings as well as the LDAP servers if the routing rule is based on
LDAP routing (and Call Setup Rules).
If only one Routing Policy is configured in the Routing Policies table,
the Routing Policy is automatically assigned. If multiple Routing
Policies are configured, no value is assigned.
To configure Routing Policies, see ''Configuring SBC Routing Policy
Rules'' on page 670.
Note: The parameter is mandatory.
General
Index
[IPOutboundManipulation_Ind
ex]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name
manipulation-name
[IPOutboundManipulation_Ma
nipulationName]
Defines an arbitrary name to easily identify the row.
The valid value is a string of up to 20 characters.
By default, no value
is defined.

AudioCodes MediaPack MP-11 Series Specifications

General

Brand	AudioCodes
Model	MediaPack MP-11 Series
Category	Gateway
Language	English