User's Manual 732 Document #: LTRT-27045
Mediant 1000B Gateway & E-SBC
2. Insert the new module:
a. Physically insert the new module into the same chassis slot in which the previous
module was housed (refer to the Hardware Installation Manual).
b. On the Monitor home page, click the title of the module ("<module type>
Reserved") that you are replacing; the Insert Module button appears:
c. Click the Insert Module button; a message appears informing you that this may
take a few seconds. When the message disappears, the module is inserted,
indicated by the disappearance of the word 'Reserved' from the module's name.
To Next Page
Loading...
Need help?
General
