5.2.2 Configuration for alarm contacts (collective fault signal): view/edit
Æ
Via the menu to parameter:
MAIN MENU (M0)
SETTINGS (M1)
I/O 1 (M14)
ALARM CONTACT (M1411)
Default value: FAULT GROUP 3
Information Faults interrupt or prevent the electrical operation of the actuator.
È
Description of the parameter settings:
The alarm contacts can be assigned to the same signals as
BYTE 5.7
CONFIG.
, table 9, page 25.
29
Actuator controls
Manual AUMATIC AC 01.1/ACExC 01.1 Profibus DP
EDIT M1411
ALARM CONTACT
FAULT GROUP 3
:EDIT ¿:OK C:ESC
To Next Page
Loading...
