AUMA Aumatic AC 01.1 User Manual

7.9 Local controls enable function (option)
The selector switch functions on the local controls (LOCAL, OFF, and
REMOTE) may be either enabled or disabled.
In addition, an automatic release can be programmed for the event of a bus
loss.
7.9.1 Selector switch functions: enable/disable
This value is set in the factory and can only be changed by the AUMA ser-
vice.
Æ
Via the menu to parameter:
MAIN MENU (M0)
CONFIGURATION (M4)
SETUP (M41)
ENABLE LOCAL MODE (M410W)
Default value: NOT ACTIVE
È
Description of the parameter settings:
NOT ACTIVE
All selector switch functions are enabled.
BUS
The selector switch is enabled via fieldbus.
The AUMATIC can be set in such a way that the AUMATIC internal selector
switch position may additionally be determined by 3 bits in the process rep-
resentation output.
If a selector switch is available, the signals via the bus have to match the
actual selector switch position to enable a release. If there is no selector
switch, the release is only controlled by the signals via bus.
BUS, AUTO LOCAL
The selector switch is enabled via fieldbus.
This setting is only permissible if the local controls is equipped with a selec-
tor switch
.
In case of bus failure, the selector switch positions LOCAL and OFF are
enabled to allow actuator operation via the push buttons.
BUS, AUTO LOCAL II
The selector switch positions LOCAL and OFF are enabled via fieldbus.
This setting is only permissible if the local controls is equipped with a selec-
tor switch.
If the command “AUMATIC changes to REMOTE” is sent, the internal
AUAMTIC selector switch position is always REMOTE, irrespective of the
actual selector switch position. In case of bus failure, the selector switch
positions LOCAL and OFF are enabled to allow actuator operation via the
push buttons.
Information Observe during commissioning and maintenance: Any control from RE
-
MOTE via the system cannot be interrupted or blocked locally via the selector
switch position.
73
Actuator controls
Manual AUMATIC AC 01.1/ACExC 01.1 Profibus DP
VIEW
ENABLE LOCAL MODE
NOT ACTIVE
C:ESC

AUMA Aumatic AC 01.1 Specifications

General

Brand	AUMA
Model	Aumatic AC 01.1
Category	Control Unit
Language	English