Replacing the SAMP on the Avaya S8500B server
03-300529 Issue 4 January 2008 119
Reconnecting cables on the S8500B server
After the server is replaced and secured in the rack, reconnect the all but the power cable to the
server, SAMP, and modem. If you are unsure about the connections, see S8500B server
connections on page 121.
Powering up the S8500B server
To power up the server:
1. Plug the power cord into the power receptacle on the rear of the server.
2. If necessary press the Power button located on the front right-hand side.
3. Verify that there is network activity by looking at the network activity LEDs (see Figure 30
).
Figure 30: S8500B server rear panel network activity LEDs
4. Log into the server after the startup to make sure that the installation is complete.
5. Check the original Ethernet configuration settings by selecting Server Configuration >
Configure Server from the Maintenance Web Interface.
6. Confirm that the server’s Ethernet configuration settings are the same as before.
Figure notes:
1. Network activity LED (Tx/Rx) 2. Connection rate:
l Off: a 10BASE-T active link
l Green: a 100BASE-T active link
l Orange: a 1000BASE-T active link
2
h3msble7 KLC 110104
1
1
2
To Next Page
Loading...
