Avaya S8500 Series - Job Aid: Replacing the IP Server Interface; Removing the IPSI Circuit Pack

03-300529 Issue 4 January 2008 163
Job Aid: Replacing the IP Server Interface
This procedure describes how to replace the TN2312BP (IPSI) circuit pack (Material ID
700260359) and applies to the Avaya S8700 series and the Avaya S8500 servers.
!
Important:
Important: Always check the Avaya Support Website for Product Support Notices at
http://support.avaya.com
and select Product Support Notices (All Avaya
products) in the MOST POPULAR PRODUCTS IN SUPPORT section.
Removing the IPSI circuit pack
ELECTROSTATIC ALERT:
ELECTROSTATIC ALERT: Be sure to wear a grounded wrist strap, stand on an approved mat, or work on a
treated surface that will reduce the possibility of electrostatic discharge.
To remove the IP Server Interface (IPSI) circuit pack:
1. Look up the old IPSI circuit pack administration (display ipserver-interface
location). Note whether the IPSI circuit pack has an administered (static) IP address or is
supplied an IP address from a DHCP server.
2. Busyout the circuit pack (busyout ipserver-interface location).
3. Unlatch the circuit pack handle.
4. Pull the circuit pack completely out of the gateway carrier.