Expanded Procedures
03-300529 Issue 4 January 2008 91
5. Slide the drive cage into place in the server, making sure that it fits securely into the four
retaining hooks and finger-tighten the captive screw.
6. Make sure the drive cage is secure and that the cables are not bunched or blocking the fan
unit.
Replacing the cover of the S8500 server
For these steps, see Figure 19: Removing and replacing the cover on the S8500 server on
page 89.
1. Place the cover onto the server.
2. Slide the cover forward so the covers’ tabs slide into place under the top slots of the front
panel.
3. Finger-tighten the captive screws on the back of the server.
4. Return to Tasks for replacing a hard drive on an S8500 server
on page 79 to continue with
the listed tasks.
Expanded Procedures
This section contains information about the following topics:
l Installing Communication Manager
l Installing post-upgrade patch files
l Restoring the system files
l Verifying the server configuration
To Next Page
Loading...
