Job Aid: Replacing the Avaya S8500/B/C server
44 Job Aids for Field Replacements (FRUs) for the Avaya S8500 Server
Removing the S8500B server from the rack
To remove the S8500 B server from the rack:
1. Label and disconnect all cables on the server.
2. Loosen the two front thumbscrews on the server.
3. Carefully pull the server from the rack.
Removing the cover of the S8500B server
For these steps see Figure 7: Removing and replacing the cover on the S8500B server on
page 44.
1. Set the server down on a flat surface with an electrostatic mat.
2. Loosen the captive screw on the back of the server that holds the cover in place.
3. Slide the server cover back from the front panel until the cover’s tabs are released from the
top slot of the front panel.
4. Lift the cover straight up and remove it from the server.
Figure 7: Removing and replacing the cover on the S8500B server
Figure notes:
1. Captive screw on the S8500B server
h3dscapb KLC 093004
1
To Next Page
Loading...
